Cleaning And Maintenance; Technical Specifications - HQ Power PROCD3000 Mode D'emploi

6. How to use the CUE (with play / pause)
1. In PAUSE mode, press the CUE button to memorize a point for playing back. This point is called CUE POINT.
2. In PLAY mode, press the CUE button to return the music back to the CUE POINT and keep it in the PAUSE mode.
3. Press the PLAY button again to perform from the CUE POINT.
7. How to use the A and B/LOOP
1. In PLAY mode, set an A point by pressing the A button (without interruption during playback).
2. Press B/LOOP to memorize the ending point of the loop. We call this the B point. LOOP is shown on the LCD and
the music automatically comes back to the A point and loops between the A and B points.
3. While the music loops between A and B, press the B/LOOP button to leave the loop. At that time, LOOP is shown
on the LCD.
4. Press RELOOP again during playback to return to the loop function.
5. Within play interval, you can change the A point and B point in PAUSE mode by pressing the A & B/LOOP button
under PLAY mode.
6. Change the starting point by pressing the A button in PAUSE mode during the LOOP function.
7. The interval between A & B point must be more than 20 frames or the B point will be cancelled.

8. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections, ...
3. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
4. Disconnect the device from the mains prior to maintenance activities.
5. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
6. There are no user-serviceable parts.
7. Contact your dealer for spare parts if necessary.

9. Technical Specifications

Output level
Frequency response
THD
Channel separation
S/N ratio
Outputs
Power Supply
Dimensions main unit
Dimensions control unit
9. Troubleshooting
Symptom
POWER SWITCH is set to ON but
no power
The disc does not start
No sound
PROCD3000
2Vpp @ 47K Ohms
20 – 20 000 Hz (+/- 2dB)
< 0.03%
> 70dB
> 70dB
2 x analogue stereo RCA and 2 x digital RCA
max. 230Vac/50Hz (35W)
482 x 88 x 250mm (19'' x 2U)
482 x 133 x 60mm (19'' x 3U)
Possible cause
Poor power plug connection at the
AC outlet
- The disc is loaded upside down
- The disc is too dirty
- Improper output cable connections
- Improper amplifier operation
5
Solution
Insert the power plug firmly into the
AC outlet
- Reload the disc with the label side
up
- Clean the disc
- Connect the output cable properly
- Make sure that the amplifier
controls are set properly
VELLEMAN