HQ Power PROCD3000 Mode D'emploi page 4

13. PITCH button
Press this button to switch to PITCH ON mode. Select the 8% or 16% button to assign +/- 8% or 16% to the pitch
control slider. When the unit is in PITCH OFF mode, the playback speed is normal (0%). The playback speed will
not change when you move the pitch control slider.
14. PITCH CONTROL slider
Move the PITCH CONTROL slider to choose the desired range between minimum (up) and maximum (down) to
match the playback speed (8%, 16%).
15. PITCH BEND +/- button
Match the position of the bass beat after the pitch has been adjusted. The pitch will automatically rise up to +16%
from the current setting by pressing the + button. By pressing the – button, the pitch will automatically drop to -
16% from the current setting. By changing the pitch you can match the position of the beats.
16. JOG WHEEL
Speed control: Rotate the wheel in the PLAY mode to change the playback speed. Rotating in a clockwise
direction will increase the speed; rotating in a counter clockwise direction will decrease the speed.
Searching: Rotate the wheel in PAUSE mode to forward or backward the player to the desired point of start. The
searching speed changes according to the rotation speed.
17. SEAMLESS LOOP (2 sets)
Use the A, B/LOOP/EXIT and RELOOP buttons.
A button: Starting point (A point.) Also CUE 1 could be an A point. After setting up the A point, the red LED will
be lit.
B/LOOP/EXIT button: Ending point (B point). Press the B/LOOP button to set up the B point and start the loop
playback automatically. LOOP is shown on the display and the 3 LEDs flash. Press this button again to exit the
LOOP playback.
RELOOP button: Return to the loop playback by pressing RELOOP while in performance.
Changing STARTING and ENDING POINT: Press the A and B/LOOP/EXIT button again.
The interval between A and B must be more than 20 frames. Otherwise, the B point will be cancelled.
18. RELAY
When one unit is in PLAY mode, the other unit will be in PAUSE mode. Pause the playing unit to let the other unit
automatically start the unit.
19. PROGRAM button
Program the desired track. While the unit is stopped, press the PROG button first to enter the MEMORY mode.
Press the skip buttons to select the desired tracks and press the PROG button again to confirm. The maximum
number of programmable tracks is 28. While playing programmed tracks, the PROG LED is lit.
20. BPM button
Push this button to get the BPM (beats per minute) value.
21. DIRECT ACCESS key (0~9)
Select the track number to be played.
22. CONNECTOR PORTS
8-pin connection of the control unit to the main unit.
23. SLEEP
The device will switch off automatically when unused for more than 30 minutes.
5. Connections
Connect the connection cables to the line outputs of your mixer. The connection cables and the remote control
connection cable are supplied with the main unit. Make sure you use the supplied remote control connection cable.
The use of another type of cable might cause damage.
PROCD3000 4 VELLEMAN