Angle Measurement; Laser Beam - geo-FENNEL Multi-Digit Pro + Mode D'emploi

EN
SLOPE MEASUREMENT
Switch on Multi-Digit Pro +.
The measured inclination value is shown in the left display. The standard unit of measurement is
degrees (°) – this can be changed to percent (%) by pressing the button „MODE" . Lay down the unit on
the surface with the blank bottom side only.
The 2 arrows in the display indicate in which direction Multi-Digit Pro + has to be moved in order to
reach 0° or 90°-position.
0° - 45,0° leading to 0°-position
45,1° - 90° leading to 90°-position
The exact „0"-position is shown by the double- arrows.
The display has an automatic digit inversion for overhead
measurements. The reading of the measured values is possible in
every position.

ANGLE MEASUREMENT

The measured angle value is shown in the right display (0 - 180°).

LASER BEAM

By switching on the laser beam Multi-Digit Pro + can be used as a laser spirit level, too. The working
range extends up to 20 m.
The height of the laser from the base is 30.5 mm.
LOCKING OF ARM
The angle ruler can be locked in any desired position. For example: an angle of 90° to transfer right
angles; or an angle of 180° to extend the unit to 1 m (see picture):
15