geo-FENNEL Multi-Digit Pro + Mode D'emploi page 12

EN
C
FEATURES
1
2
1) ON/OFF
Press the button short to switch on/off Multi Digit Pro +.
2) LASER / CAL
Press the button short to switch on/off the laser beam.
Press the button long to activate the angle calibration procedure (see „Check and calibration").
3) CAL
Press the button long to activate the calibration of the horizontal angle (see „Check and calibration").
4) MODE
Press the button short to select 5 different display modes (see „Additional functions").
5) SOUND / ILLUMINATION
Press the button short to switch on/off the sound signal.
Press the button long to switch on/off the illumination.
6) HOLD
Press the button short to freeze and to release the current reading.
7) SLOPE INDICATION
8) ANGLE INDICATION
Button
Press the button long to switch on/off the signal tone - (0°-position of the inclination will be confirmed
by a signal tone).
Press the button long to switch on the backlight illumination.
HOLD
Current readings of inclination and angle will be frozen by pressing HOLD (figures are flashing).
By pressing HOLD again figures will be released.
9
12
8
7
3 4
11
10
12
6
5
13
9)
10)
11)
12)
13)
14)
14
Direction symbol (approching
the 0°/90° position)
Symbol sound on/off
Battery status indicator
Unit symbol N/FT
Unit symbol °/%
Unit symbol mm/m