Using The Voltage Converter - AEG JP 10 Mode D'emploi D'origine

14. Press the „+" (10) or „-" button (9) until the set
value in the display (4) corresponds with the
desired pressure.
15. Set the On/Off switch (15) to „I" to switch on the
compressor.
note:
The compressor can be switched off at any time by
setting the On/Off switch (15) to the „O" position.
The compressor increases the pressure according to
the set value and stops automatically.
Attention!
Observe and check the firmness of the item whilst
inflating. If the item has already been overinflated,
immediately interrupt the process and switch the
compressor off! Attention! Excessive air pressure
may cause the item to burst! Risk of personal injury
and property damage!
16. Set the On/Off switch (15) to „0" to switch off the
compressor.
17. Remove the valve adapter from the item's valve
and close the item's valve cap.
Non-binding pressure guidelines
Object Pressure
Automotive tyre approx. 1,9 - 3,5 bar
Trailer tyre approx. 2,4 - 3,4 bar
Motorcycle tyre approx. 1,7 - 2,9 bar
Bicycle tyre approx. 2,0 - 4,0 bar
Football approx. 0,6 - 1,1 bar
Attention!
Observe the specifications of the manufacturer of
the product. Do not use the compressor to inflate
flotation devices!

Using the voltage converter

Attention!
Some external devices, particularly radios and/or
other audio devices and rechargeable devices may
not be suitable for operation via voltage converter
and could result in damage to the connected device
or the voltage converter. Please refer to the opera-
ting instructions of the device you wish to connect.
Immediately switch off and unplug the device if it
„buzzes" or becomes very hot. If you are unsure
about something, please contact the retailer for
your external device.
The 230 V power socket (18), the 12 V car socket
(12) and the USB port (8) can be used simultane-
ously. The total rated power of the external devices
connected to the 230 V socket, the 12 V car socket
and the USB port must not exceed the rated power
of the voltage converter (see „Technical data").
note:
•
The power rating of an external device is indica-
ted on the technical label which is affixed to the
particular external device. External devices such
as electric motors, e.g. drills, electric saws, refrige-
rators and music systems usually have a greater
power rating at the start up than is specified on
the technical label.
•
If the power rating is only given in Amps, simply
multiply the A value by the factor 230 to obtain
the equivalent in Watt.
•
Remember the battery pack of the device will be
discharged when operating the voltage converter.
Using the 230 V socket
Only use external devices with Schuko plug or
European cable connectors.
1. Press the „220V" button (7) to switch on the
230 V power socket (18).
2. Connect the plug of an external device to the
230 V socket (18).
3. After using the external device, disconnect the
12 V car plug from the 12 V car socket.
4. Press the „220V" button (7) again to switch off
the 230 V power socket (18).
English 33