Operation; Charging The Storage Battery; Powering The Unit On / Off - AEG JP 10 Mode D'emploi D'origine

30 www.aeg-automotive.com
1. „12V" button
2. „USB" button
3. Carrying handle
4. Display
5. LEDs
6. Light button
7. „220V" button
8. uSB port
9. „-" button
10. „+" button
11. „MENU" button
12. 12 V car socket
13. „JUMP START" dial
14. Storage compartment
15. Compressor On/Off switch
16. Charging LED, green
17. Mains socket
18. 230 V socket
19. Fuse
20. Red cable with clamp (+)
21. Black cable with clamp (-)
22. high-pressure hose
23. Valve quick coupling
24. Valve for inflatable toys
25. Valve for inflatable toys
26. Valve for sports balls
27. Power supply with 230 V power plug
28. Connecting plug

OPERATIOn

Charging the storage battery

•
The storage battery should be fully charged prior
to first use.
•
Regularly check the charge of the battery pack
when stored for extended periods.
•
Fully charge the battery pack monthly, even if the
device was not used.
Charging by 230 V charging mains adapter
1. Connect the plug (28) of the power supply to the
socket (17).
2. Connect the power supply (27) to a 230 V mains
socket. The charging LED (16) lights up green.
3. The LED indicator (4) lights up, showing the
current battery pack capacity. The charging time
is approx. 20 - 22 hours.
4. After charging, disconnect the power supply
from the device and the 230 V power socket.
note!
Do not operate the device while charging!

Powering the unit On / Off

Automatic start warning!
If the On / Off switch (15) for compressor power is
set to ( I ) before switching the unit on, the com-
pressor will automatically start and compressed air
will be supplied to the compressed air hose. Risk of
property damage and personal injury!
1. Press the „MENU" button (11). The display (4)
shows the current capacity of the integrated
battery pack.
2. If the device is not used for 50 seconds, the dis-
play will automatically switch off to save energy.