Beta 1498/12 Mode D'emploi page 12

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
REPLACING POWER SUPPLY FUSE (CIGARETTE LIGHTER PLUG)
The fuse is located in the cigarette lighter plug. Make sure that the power supply is not connected
to the mains.
Loosen the ring nut on the plug head by hand; remove the damaged fuse and replace it with a fuse
with the same characteristics. Lock the ring nut by hand.
TROUBLESHOOTING
Only one or two LEDs go on; you have been
trying to charge the starter for over 24 hours,
and the other LEDs do not go on.
No LEDs turn on, but when the charger is
plugged in, all the LEDs turn on.
The starter is fully charged, but it does not
work.
Item 1498/24 – The starter works at 12V, but
it does not work at 24V.
While charging, the "FAULT" LED goes on on
the power supply of the 12V-24V starter.
GENERAL QUESTIONS AND ANSWERS
How many starts can the starter perform with
one charge?
Can the battery of the starter be replaced?
Which is the optimal storage temperature?
Can I charge the starter with a charger with
similar characteristics?
12
PROBLEM
QUESTION
SOLUTION
Check that the LEDs on the power supply are on.
Check that the fuse in the cigarette lighter plug of
the power supply is not defective.
Please contact your dealer.
Defective battery. The starter may have been
subjected to excessively intensive use, without ha-
ving been allowed to cool down. Please also refer
to the operating instructions
Check that that the cables are firmly connected to
the posts of the battery.
Either battery is defective, or the selector switch
does not work properly. Please contact your
dealer.
Please contact your dealer.
ANSWER
The number may vary from 1 to 30, depending on the
temperature, the general condition of the vehicle, the
type and dimensions of the engine.
Yes, it can. Please contact your dealer.
The optimal temperature to preserve the internal
battery is 25 °C.
No, you can't. You can only use the charger sup-
plied with the product. You can reorder the charger
from your dealer, if need be.
EN I