Technical Data - Beta 1498/12 Mode D'emploi

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
PERSONAL PROTECTIVE EQUIPMENT TO WEAR WHILE OPERATING PORTABLE STARTER
Failure to observe the following warnings may result in physical injury and/or disease.
ALWAYS WEAR SAFETY SHOES
ALWAYS USE PROTECTIVE GLOVES AGAINST PHYSICAL AGENTS WHILE OPERATING DEVICE
ALWAYS WEAR EYE PROTECTION
Additional personal protective equipment to wear according to the values found in the
environmental hygiene/risk analysis survey if the values exceed the limits under current
regulations.

TECHNICAL DATA

FOR USE WITH BATTERIES
CHARGER VOLTAGE RATING
INTERNAL BATTERY
PICK-UP CURRENT
CLIP CABLE LENGTH
OPERATING TEMPERATURE
DIMENSIONS
WEIGHT
CHARGE LEVEL DISPLAY
To display the level of charge, press the yellow button on the front of the starter; the LEDs will turn on:
• 4 LEDs - starter is fully charged.
• 5 LEDs - maximum starter charge (the 5th LED will be displayed when the starter is still connected
to the mains power supply, or for a few seconds when it is disconnected from the power supply).
NB: Charge the starter for at least 12 hours immediately after purchase. If not used for a long
period of time, charge the starter at least every three months, to maintain the internal battery in
full working order.
10
Item 1498/12
12V
230V ~ 50/60Hz
12V-sealed lead acid battery (AGM)
2200A
1m
-10°C +40°C
400x330x140 mm
13kg
Item 1498/24
12-24V
230V ~ 50/60Hz
2x12V-sealed lead acid battery (AGM)
4200A (12V) – 2100A (24V)
1.5m
-10°C +40°C
400x330x190 mm
17kg
EN I