Audiovox AA-9300 Guide D'installation Et D'utilisation page 7

in.
Check :
A. Verify that the fuse in the red wire from the siren control
module is in good condition. Replace it if it is blown.
B. Verify that the connections of the red and black wires
have been made according to the wiring section of this
manual.
Symptom : The transmitters will not program to the siren control
module.
Check :
A. You have only 15 seconds after applying power to the
siren control module in which to program both transmit-
ters.
Symptom : The alarm will not arm and disarm using the keychain
transmitter.
Check :
A. Verify the transmitter battery is in good condition. Try
both transmitters. Replace the transmitter battery if
necessary.
B. Verify that the transmitter is programmed to the siren
control module. When the vehicle's battery is discon-
nected, or when power is removed from the siren
control module, the transmitters need to be re -
programmed. Follow the programming instructions in
this manual.
C. Verify that the fuse in the red wire from the siren control
module is in good condition. Replace it if it is blown.
D. Verify that the connections of the red and black wires
have been made according to the wiring section of this
manual.
Page 5