Operation - Hilti SFL 36­A Mode D'emploi

Check that the battery is seated securely in the appliance.
6.4 Removing the SFL 14­A battery
1. Press the release button at the rear of the battery.
2. Pull the battery out of the power tool toward the rear.
6.5 Removing the SFL 36­A and SFL 22­A battery
1. Press both battery release buttons.
2. Pull the battery out of the power tool toward the rear.

7 Operation

7.1 Switching on / off
Press the on / off switch.
7.2 Rotating the lamp body
CAUTION
Do not point the lamp towards yourself or other persons. Do not, under
any circumstances, look into the lamp. There is a risk of dazzling
yourself and causing damage to the retina of the eye.
The lamp body can be rotated. Please note that the lamp body can be
rotated only in one direction and only as far as the end stop. Do not attempt
to force the lamp body past the end stop.
7.3 Storage and transport position
Rotate the lamp body by turning the knob, overcoming the slight resistance
of the position in which it engages, until the reflector is pointing towards the
battery.
The lamp switches off automatically and can then be stored or transported.
The lamp cannot be switched on when in the storage position. Rotate the
lamp body until the reflector is pointing upwards and switch the lamp on.
Printed: 08.07.2013 | Doc-Nr: PUB / 5071526 / 000 / 02
2
3 4
5 6
en
21