Paradigm DEFIANCE WT Série Manuel De L'utilisateur page 4

CONNECTION
Connecting the Wireless Receiver
To install the Defiance WT wireless receiver,
slide it into the Wireless Module Connection
port on the back of the subwoofer. See Fig.1a
and Fig. 1b.
Connecting the Wireless Transmitter
Connection to the Defiance WT Wireless
transmitter can be made in either of two
ways:
1. Line-Level Input From Sub/LFE Output
Follow the instructions for this connection
option in the following section of the
Defiance Subwoofer Owners Manual:
"Connecting the Defiance WT Wireless
Transmitter".
2. Line-Level Input From Pre-Out/Front-Out
Without High-Pass Output from Sub
Follow the instructions for this connection
option in the following section of the
Defiance Subwoofer Owners Manual:
"Connecting the Defiance WT Wireless
Transmitter".
TRANSMITTER/
RECEIVER SYNC
This Defiance WT Wireless System is
shipped already paired. To re-sync the
wireless system:
1. Verify the subwoofer is powered on and
that the subwoofer's status light is red or
white.
2. If this Wireless Transmitter's power cord
is plugged in, unplug it for 10 seconds.
3. Plug in the Wireless Transmitter's power
cord.
3
Wireless Module Connection
Wireless Module Connection
Fig. 1a Defiance WT wireless module receptacle,
located on subwoofer.
Fig. 1b Defiance WT wireless receiver installation.
4. Plug the Wireless Receiver into the
"Wireless Module Connection" input
on the back of the subwoofer (see
diagram above).
5. Wait until the status lights start flashing
on both the Wireless Receiver and the
Wireless Transmitter.
6. Push the Wireless Receiver's sync button
for 5 seconds.
7. Push and hold the Wireless Transmitter's
sync button until the Wireless Receiver's
status light turns solid.