Triton TSPS 450 Instructions D'utilisation Et Consignes De Sécurité page 8

Troubleshooting
Problem
No function when ON/OFF Switch (2) is operated
Sanding Sleeve (11) does not rotate with Rubber Drum (12)
Large amounts of dust are being produced
Corrosion is forming on the Table Top (4)
Sanding drum not operating at full speed or motor sounds
different to normal
EN
8
Possible cause
No power
Defective ON/OFF Switch
Spindle Lock Nut (6) not tight enough
Dust extractor passage is blocked
Incorrect Table Insert used
Moisture is causing the Table Top to corrode
Motor over-heating
Motor faulty
Solution
Check power supply
Replace the ON/OFF Switch at an authorised Triton service
centre
Tighten Spindle Lock Nut in small increments until the
Rubber Drum secures the Sanding Sleeve
Turn off the machine at the mains. Remove the Rubber
Drum, Table Insert (10) and the Spindle Washer (9). Remove
the blockage from the dust extractor passage
Change to the correct-sized Table Insert
Using a clean dry cloth, rub a thin film of compatible
protective lubrication over the clean Table Top surface
Switch off and allow to cool for a 1/2hr
Contact an authorised Triton service centre