Publicité
Les langues disponibles
Les langues disponibles
User Manual
Installation and operation
The following graphic shows the Audio Extractor connected in a typical set up, with HDMI cables connected
between the source equipment, Audio Extractor and HDMI display equipment. Additionally, a cable is
connected between one or more of the Extractor's audio outputs and an AV receiver/amplifier.
HDMI Cable
TOSLink / Digital Coax / Phono Cable
Installation is simple, make sure that all devices are powered off and then connect the cables as described
above and then connect the provided USB DC cable to an available port on your AV equipment or to a
USB charger/power supply (such as LINDY No. 73351) and power on all devices.
The Power LED will illuminate red when the power supply is connected, whilst the Status LED will only
illuminate green when a HDMI signal is received, and both the source and display are switched on. Once
playback commences sound is output through all of the audio out interfaces simultaneously.
EDID Management
Using the dip switches on the back of the unit it is possible to control the EDID which is used by the Audio
Extractor, this will directly affect the available options for the audio and video output of your source device.
To change the setting simply move the dip switches into one of the combinations shown in the table below
(0 = Up position, 1 = Down position, X = dip switch not used). Once you have made your selection simply
power cycle the Extractor by removing and then re-inserting the DC power jack to apply the new setting.
The screen may flash on/off briefly whilst handshaking occurs, this is completely normal.
Dip Switch Setting
1
0
0
1
1
For installations using multiple HDMI sources, position the Audio Extractor between a HDMI switch and
HDMI display equipment. Installations using multiple HDMI displays require the Audio Extractor to be
positioned before a HDMI splitter.
EDID Description
2
3
0
X
EDID Passthrough up to 24bit 192Khz
1
X
2 Channel 24bit/48Khz, No encoded formats, Full
HD
0
X
2 Channel 24bit/48Khz, No encoded formats, 4K
1
X
5.1 Channel 24bit/48Khz, Dolby Digital, DTS Audio,
Full HD
English
or
Publicité
