Cleaning; Door Sealing; Remove/Reinstall The Refrigerator; Refrigerator Storage - Furrion FCR14ACBQA-BL Manuel D'instructions

Cleaning

Unplug the refrigerator before cleaning. If this is not
practical, wring excess moisture out of sponge or cloth when
cleaning around switches, lights or controls.
Use warm water and baking soda solution - about a
tablespoon (15 ml) of baking soda to a quart (1 liter) of water.
This both cleans and neutralizes odors.
After cleaning the door gaskets, apply a thin layer of
petroleum jelly to the door gaskets at the hinge side. This
helps keep the gaskets from sticking and bending out of
shape.
Avoid cleaning cold glass shelves (if equipped) with hot water
because the extreme temperature difference may cause
them to break. Handle glass shelves carefully. Bumping
tempered glass can cause it to shatter.
Do not wash any plastic refrigerator parts in the dishwasher.
Cleaning the Outside
Keep the outside clean. Wipe with a clean cloth lightly
dampened with kitchen appliance wax or mild liquid dish
detergent. Dry and polish with a clean, soft cloth.
Do not wipe the refrigerator with a soiled dish cloth or wet
towel. These may leave a residue that can erode the paint.
Do not use scouring pads, powdered cleaners, bleach or
cleaners containing bleach because these products can
scratch and weaken the paint finish.
Cleaning the Inside
To help prevent odors, leave an open box of baking soda in
the fresh food and freezer compartments.

Door Sealing

If either door does not seal correctly, excess frost will collect
inside the refrigerator. Make sure the doors seal correctly:
1. Close each door on a piece of paper that is about the size
and thickness of a dollar bill.
2. Gently pull the paper. You should feel a slight drag
between the gasket and the cabinet.
3. Do this on all four sides of the door.
4. If you do not feel a slight drag on the paper, the door does
not seal correctly Have your dealer or a Furrion authorized
service center to correct the seal of the door.
9

Remove/Reinstall the Refrigerator

Your dealer or Furrion authorized service center must do this
procedure.
CAUTION: The rear of the refrigerator has sharp edges and
corners. To prevent cuts or abrasions when working on the
refrigerator, be careful and wear cut resistant gloves.
1. Remove the AC power cord from the receptacle.
2. Remove the plastic vents from the mounting flanges of the
refrigerator.
3. Remove the screws from the upper and lower mounting
flanges on the front of the refrigerator.
4. Remove the refrigerator from the opening.
Repeat steps 4 to 1 to reinstall the refrigerator into the
enclosure.

Refrigerator Storage

Before the refrigerator is stored for an extended (seasonal)
period of time.
● Defrost and clean the interior of the refrigerator. See
"Cleaning" section for detail.
● Close the doors with the storage latch.
If the refrigerator is stored for an extended period of time,
before start up:
● Make sure there are no obstructions in the vents, the
ventilation air pathway, or the flue area.

Replacement Parts

You may purchase replacement parts through your local RV
dealer or Furrion authorized Service Center.
LED Lamp Replacement
The interior light is at the top of the fresh food compartment.
To replace a burned-out bulb:
1. Unplug the refrigerator from its receptacle.
2. Remove the LED lamp cover by pulling it downward.
3. Unscrew the screws holding the LED lamp after fully
cooled down and replace with a bulb in the same or lower
wattage.
4. Install the cover.