Assembly - TurMix Platinum Mode D'emploi

Assembly

tip
The juicer can be disassembled by following these steps in reversed order.
Enclosure
Place the enclosure ring on the base properly. In doing so, pay at­
tention to the chamfered edge and the notches on both sides.
Sieve and grater disc
Insert the sieve. Make sure to put the triangular notch on the base
above the even elevation in the enclosure. Place the grater disc with
the sharp side up. Also pay attention to the triangular notch. Fi­
nally, securely tighten the nut.
Pulp ring and lid
Firmly press the pulp ring into the bottom. Place the lid with the
feed opening at the front and lock with the locking system.
detail
Inserted pulp ring
EN
55
Assembly