Battery Charging - Vermeiren LE Mode D'emploi

The following table indicates what the battery charge indicator will display.
Display

Battery charging

Description Meaning
All LEDs dark. System off.
All LEDs are lit and System on.
the green LEds are High voltage warning:
flashing. battery voltage level has
risen above the high
voltage warning set-point.
All LEDs are lit. System on.
1 Green led is lit. System on.
Only red and amber Low battery level.
LEDs lit.
Red and amber Very low battery level.
LEDs lit.
Only Red LED lit. Battery almost empty.
1 Red Led is Battery empty.
flashing. Low voltage warning:
battery voltage level
decreased below its low
voltage warning set-point.
First red LED will Battery voltage decreases
flash on the battery below the battery cut-off
indicator. voltage.
The status indicator
will display a flash
code 2 or 7.
The horn will sound
once every 10
seconds.
Plug the battery charger into the remote's XLR
socket.
Chase 1
The battery charger indicator will indicate the system
is being charged by cycling between a left to right
chase sequence, and then displaying the
Chase 2
approximate battery charge state at the end of the
chase sequence.
Chase 3
Driving is prevented (inhibited) while the system is
being charged.
Chase 4
The LE system does not have to be powered up
when charging the battery, however, if it is not
powered up, then the battery gauge will not display
Chase 5
the charging state / chase sequence.
Charge state
4
LiNX LE
vA - 2013-05
Remarks
Warning: battery too full.
Slow down if you are
driving down a slope.
LEDs show the charge
level.: Full battery
(between 81 and 100% of
full capacity)
Battery level is decreasing.
Battery half full. Start the
return journey.
Battery low (between 0 and
20% of full capacity).
Recharge soon.
Recharge now.
Recharge immediately.
Battery is fully discharged,
and it is good practice to
stop discharge at this point.
The display and wheelchair
shut down automatically.