Operating Instructions; Ice Cube Tray; Before Using; Temperature Selection - Danby Designer DCR032C1BSLDD Guide D'utilisation Et Soins De Propriètaire

Operating Instructions

ICE CUBE TRAY
The ice cube tray is flexible. Twist tray to remove the ice cubes. If the ice cube
tray is frozen solid to the evaporator surface, run a little water over the tray.
Never use a knife or other metal instruments to remove the ice cube tray, as this
may damage the evaporator.
BEFORE USING
TEMPERATURE
SELECTION
DEFROSTING
1 Before the refrigerator is plugged in make sure the electric voltage to
be used is the same as the rated voltage. The power plug should
have its own independent socket. Using an adapter may cause the
socket to overheat.
2 Do not store flammable materials such as ether, benzene, LP gas
and glue, etc. in the refrigerator.
3 Do not splash water on the refrigerator, it may cause a malfunction or
electric shock.
4 The first time you turn the unit on, set the temperature control to "7,"
the coolest setting. Run the refrigerator without loading any food for at
least 2 hours. This ensures that the compartment has cooled down
sufficiently before placing any food inside.
To avoid vibration, the unit must be on a level surface. This is
accomplished by adjusting the leveling legs located under the refrigerator.
The temperature of the refrigerator is controlled by setting the thermostat
knob to a desired setting.
The temperature of the refrigerator can be
adjusted by turning the thermostatic dial. The
range of temperature controls is from position
"OFF," or NO COOLING to "7", the coldest.
The setting of "4" should be satisfactory for
home refrigerator use.
Defrost the freezer compartment whenever the layer of frost on the surface
of the evaporator reaches 3 or 4 mm. When defrosting, remove all food and
set the thermostat to the "OFF" position. Put the drip tray under the evapora-
tor to collect melted water. After the frost has melted, discard the melted
water and dry up the interior of refrigerator. The refrigerator can then be
restarted by turning its thermostat to the desired setting.
Note: Never use sharp or pointed instruments to remove ice from the freezer
compartment. The freezer compartment contains refrigerated gas lines and if
accidentally punched/pierced, will render the refrigerator inoperable and void
the manufacturers warranty.
DO NOT ALLOW THE REFRIGERATOR TO CONTINUE OPERATION IF
THE FREEZER COMPARTMENT IS PIERCED.
After defrosting is complete, set the control to maximum for 2 to 3 hours
before returning to the desired position. When the refrigerator is not to be
used for a long period of time, disconnect the appliance from the electrical
supply and leave the door partially open. This will help to reduce mold and
mildew build-up.
Note: Wait 3 to 5 minutes before attempting to restart the refrigerator if oper-
ation has been interrupted.
7