Safety Instructions; Electrical Connection - Zanussi ZFC26400WA Notice D'utilisation

Masquer les pouces Voir aussi pour ZFC26400WA:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Clean the appliance with a moist soft cloth. Only use neutral
detergents. Do not use abrasive products, abrasive cleaning
pads, solvents or metal objects.
Do not store explosive substances such as aerosol cans with a
flammable propellant in this appliance.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.

SAFETY INSTRUCTIONS

INSTALLATION
WARNING! Only a qualified person
must install this appliance.
Remove all the packaging.
Do not install or use a damaged appliance.
Obey the installation instruction supplied with
the appliance.
Always be careful when you move the appliance
because it is heavy. Always wear safety gloves.
Make sure the air can circulate around the
appliance.
Wait at least 4 hours before connecting the
appliance to the power supply. This is to allow
the oil to flow back in the compressor.
Do not install the appliance close to radiators or
cookers, oven or hobs.
The rear of the appliance must stand against the
wall.
Do not install the appliance where there is direct
sunlight.
Do not install this appliance in areas that are too
humid or too colds, such as the construction
appendices, garages or wine cellars.
When you move the appliance, lift it by the front
edge to avoid scratching the floor.

ELECTRICAL CONNECTION

WARNING! Risk of fire and electrical
shock.
The appliance must be earthed.
All electrical connections should be made by a
qualified electrician.
Make sure that the electrical information on the
rating plate agrees with the power supply. If not,
contact an electrician.
Always use a correctly installed shockproof
socket.
14
Do not use multi-plug adapters and extension
cables.
Make sure not to cause damage to the electrical
components (e.g. mains plug, mains cable,
compressor). Contact the Service or an
electrician to change the electrical components.
The mains cable must stay below the level of the
mains plug.
Connect the mains plug to the mains socket
only at the end of the installation. Make sure that
there is access to the mains plug after the
installation.
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
USE
WARNING! Risk of injury, burns,
electrical shock or fire.
Do not change the specification of this
appliance.
Do not put electrical appliances (e.g. ice cream
makers) in the appliance unless they are stated
applicable by the manufacturer.
Be careful not to cause damage to the
refrigerant circuit. It contains isobutane (R600a),
a natural gas with a high level of environmental
compatibility. This gas is flammable.
If damage occurs to the refrigerant circuit, make
sure that there are no flames and sources of
ignition in the room. Ventilate the room.
Do not let hot items to touch the plastic parts of
the appliance.
Do not put soft drinks in the freezer
compartment. This will create pressure on the
drink container.
Do not store flammable gas and liquid in the
appliance.
Do not put flammable products or items that are
wet with flammable products in, near or on the
appliance.

Publicité

Table des Matières
loading

Table des Matières