Thermostatic Head Installation - Cordivari My Head Notice D'emploi

English
All top LEDs are orange. Botton LED is green
during 1s.
1st LED blinks red and user is allowed to choose
setup menu number by turning the rotary switch.
Push the OK button to validate the Setup menu
from 1 to 6
To exit the Set Up 2 menu, make no action on the thermostatic head
during 30s.

2.2 Thermostatic head installation

All procedures listed in this chapter must be done before installing
My Head to the radiator.
This step allows the motor to learn the stroke of the thermostatic radiator
valve.
In the set-up1 menu,
Push OK
All LEDs are OFF during motor back move
1st LED is FIX GREEN AGAIN when the HEAD is completely opened
You can then install the thermostatic head on your heater.
STEP 1
Screw the Adaptor nut on the heater
STEP 2
Fix the brackets on the Adaptor nut and the
thermostatic head
STEP 3
Fix the 2 screws on the brackets
PUSH OK , red LED will be ON before starting the
move
ALL LEDS are OFF during Motor out move
After this learning procedure:
1. Return to MAIN menu automatically (ON or OFF mode) if no prob-
lem
2. Show "STROKE ERROR" if problem
2.3 RF pairing on the central unit (option)
This step allows to pair the Cordivari My Head to the central unit for re-
mote control including programing.
In the set-up1 menu select the 2nd LED,
2nd LED is red FIX if no Central is link
- 12 -
Cod. 1910000000260 - nv00