Hkoenig SWRC130 Manuel D'utilisation page 15

2. The charging station cannot be used in environments with strong reflection such as direct
sunlight or nearby mirrors. If there is any object with strong reflection, please cover it 7cm from the
bottom.
3. In order to ensure the normal working hours of the host, please fully charge it before use.
The charging time is about 5 hours.
4. When charging, do not assemble the water tank assembly to the robot vacuum, so as to
ensure the safety of charging and prevent wet mops from damaging the floor.
5. During the cleaning process, the host can sense that its power is insufficient and
automatically start the recharging mode to find the charging station to recharge. You can also
command the host to start the recharging mode
remote controller.
PRODUCT USE / START CLEANING
According to different cleaning needs, the product has a variety of cleaning modes to choose from.
You can start
various cleaning modes through a host, remote control or app.
Automatic Cleaning
Setting method: In the shutdown state, press the button
indicator light
button on the host is pressed for a short time, or press the automatic cleaning
button on the remote controller, the host starts automatic cleaning.
If it is dustbin instead of water tank installed in the host, and in standby mode or other
working modes, press the button
cleaning. Press the button
the button once more, the host will switch to quiet cleaning mode. Pressing the button
additionally more times will make the host switch between powerful suction mode and
quiet cleaning mode circularly.
If the water tank is installed in the host, and in standby or other working modes, pressing
the button will always make the host enter into mopping mode.
MOPPING MODE
Applicable scenario: Used to do wet & dry mopping.
Setting method: Install the water tank to the host and press the start button
host or the button
(Attention: If the water tank is not installed, press the button
controller, the host will prompt that the water tank is not installed and the host will not
work at this status.)
Press the button
cleaning mode.
Attention： When manual charging, please keep the front bumper of the
robot 2cm away from the charging station to ensure the metal contacts
connected well for a successful charging
of the host is on, it indicates that the host is powered on. When the
again, the host will switch to powerful suction mode. Press
or ( ) on the remote controller, the host starts mopping mode.
( ), the host will switch to single room
through the recharging button
on the remote controller, the host starts automatic
for a few seconds. When the
( ) on the remote
on the
on the