Orkli OKSOL Manuel D'installation page 24

EN
INSTALLATION OF THE SUPPORT FRAMES ON TILTED ROOF
The OKSOL solar system must be installed using Orkli´s support frames designed for this purpose.
Depending on the roof, it will be necessary to lean the set "OKSOL+Orkli´s support frame" on some
auxiliary profiles that allow the final anchoring to the building. 2 examples of auxiliary profiles are shown
below:
AUXILIARY
PROFILES
Those auxiliary profiles, as well as any element to fix the system to the roof (that may vary depending
on its material: concrete, wooden beams, steel beams,...) are not included in Orkli´s support frame kit.
The steps to be followed are as follows:
1. Preassemble the two frame supports:
2 x
24