baumarkt TI0190 Manuel D'instructions page 32

Installation
3. Mount four of the assembly rails to corners of basic plate using two bolts for
each corner.
4. Mount the remaining four assembly rails at requested position to
the already mounted assembly rails using four bolts each.
The upper and lower mounting rails must overlap by at
Important!
least 10 cm.
1. Now fix the flexible exhaust hose in the exhaust hole. The necessary
For extraction mode only
installation materials (hose clip) can be found in specialist shops or
hardware stores.
1. Position the chimney panel in such a way that the ventilation slits are on the
For extraction and circulating air mode
side and fasten in place on the base plate with four screws.
12
Preparation