Troubleshooting
8
Troubleshooting
Problem
Your device is not
working (plug is
inserted).
When operating from
the DC socket (ciga-
rette lighter):
The ignition is on and
the cooler is not work-
ing.
9
Guarantee
The statutory warranty period applies. If the product is defective, please
contact the manufacturer's branch in your country (see the back of the
instruction manual for the addresses) or your retailer.
For repair and guarantee processing, please include the following docu-
ments when you send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
26
Possible cause
There is no voltage flowing
from the DC socket (ciga-
rette lighter) in your vehicle.
No voltage present in the
AC voltage socket.
The inner fan or the cooling
element or the compressor
is defective.
The fuse of the DC plug is
dirty. This results in a poor
electrical contact.
The fuse of the DC plug has
blown.
The vehicle fuse has blown. Replace the vehicle's DC socket fuse
Suggested remedy
The ignition must be switched on in
most vehicles to supply current to the
cigarette lighter.
Try using another plug socket.
This can only be repaired by an
authorised repair centre.
If the plug of your cooler becomes very
warm in the DC socket fitting, either the
fitting must be cleaned or the plug has
not been assembled correctly.
Replace the fuse of the DC plug with
one of the same rating (fig. 3 1,
page 3).
(usually 15 A). (Please refer to the
operating manual of your vehicle.)
CK40D Hybrid
EN