Troubleshooting; Disposal - Dometic Bordbar CDF-11 Notice D'emploi

All manuals and user guides at all-guides.com
BordBar CDF-11
7

Troubleshooting

Fault
Device does not function,
"POWER" LED does not
glow.
The device does not cool
(plug is inserted, "POWER"
LED is lit).
The device does not cool
(plug is inserted, "POWER"
LED flashes, the display is
blank).
When operating from the
12/24V socket (cigarette
lighter):
The ignition is on andthe
device is not working and
the "POWER" LED isnot lit.
Pull the plug out of the
socket and make the follow-
ing checks.
"ERROR" LED flashes and
the display shows "ERR1"
or "ERR2".
8

Disposal

Place the packaging material in the appropriate recycling waste bins
wherever possible.
If you wish to finally dispose of the device, ask your local recycling
centre or specialist dealer for details about how to do this in
accordance with the applicable disposal regulations.
Possible cause Suggested remedy
There is no voltage The ignition must be switched on in
present in the 12/24 V most vehicles to apply current to the
socket (cigarette cigarette lighter.
lighter) in your
vehicle.
Defective compressor.This can only be repaired by an author-
ised customer repair agent.
The voltage present in Check the battery and charge if neces-
the 12/24V socket is sary.
too low.
Check the wiring and connections.
The cigarette lighter If the plug of your cooler becomes very
socket is dirty. This warm in the cigarette lighter socket,
results in a poor elec- either the lighter socket must be
trical contact. cleaned or the plug has not been
assembled correctly.
The fuse of the Replace the fuse (5 A) in the cigarette
12/24V plug has lighter plug, see "Replacing the plug
blown. fuse (12/24 V)" on page28.
The vehicle fuse has Replace the vehicle's 12/24V socket
blown. fuse (usually 15A). Please refer to
your vehicle's operating manual.
Device is defective. This can only be repaired by an author-
ised customer repair agent.
Troubleshooting
15