After Use - Princess 332770 Mode D'emploi

CAUTION: Be careful of the steam during steaming.
During operation, the steamer hose may make a gurgling noise. This is normal because of condensation.
If it begins to gurgle, extend hose up and out to move excess moisture back into the base.
9. 2 in 1 Brush (Lint & Bristle) (03)
Be sure unit is unplugged and completely cool before attaching this accessory.
Attach the 2 in 1 brush to the steam head by lining up the bottom of the brush with the bottom of the
steam head. Gently push the top of the brush into place on the steam head until it clicks into place.
- Gently brush the area to be steamed following the grain or nap of the fabric.
- Remove the fabric brush once unit is unplugged and completely cool by pressing on the release tab on
top of brush while pulling it forward.

AFTER USE

1. After using the steamer, push the on/off switch to the O position. The power indicator goes off. You can
then remove the plug from socket.
2. Place back the steam head on the steamer unit.
3. Remove the hose clamp.
4. Remove the hose from hose adaptor.
* Make sure the unit has completely cooled down before removing it from the Hose Adaptor.
4. Store the steam hose in the hose wrapping position (06) when not in use for easy storage.
5. Turn the reservoir cover out from the unit anticlockwise and empty the water container from the opening
of the hose adaptor, and lock the reservoir cover back into place.
6. You can carry your steamer by its handle for easy portability and storage.
7. For cord and hose winding or transport, never turn your appliance upside down.
Empty all water from the unit before storing it.
WARNING:
Never touch the steam head until it cools completely
Never operate without water.
Unplug after each time use.
13