D-Link DWA-140 Guide D'installation page 40

Industry Canada Notice:
This device complies with Canadian RSS-210
"This Class B digital apparatus complies with Candadian ICES-003"
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
IC statement
Operation is subject to the following two conditions:
(1)This device may not cause interference and
(2)This device must accept any interference, including interference
that may cause undesired operation of the device.
This device has been designed to operate with an antenna having a
maximum gain of 2.12 dBi. Antenna having a higher gain is strictly
prohibited per regulations of Industry Canada. The required
antenna impedance is 50 ohms.
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth
for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance.
This EUT is compliance with SAR for general
population/uncontrolled exposure limits in IC RSS-102 and had
been tested in accordance with the measurement methods and
procedures specified in IEEE 1528. This equipment should be
installed and operated with minimum distance 1.5cm between the
radiator & your body.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
For products available in the USA/Canada market, only channel
1~11 can be operated. Selection of other channels is not possible.