Whirlpool GLADIATOR EZ CONNECT Instructions D'assemblage page 5

1.
Attach support beams to bottom
post
P1
P4
Use bottom post (P1) and attach horizontal support beam
(P3) across front, and attach side support beam (P4) to
other side. This will give you support while building your
shelves up. You have now assembled one corner.
3.
Add tie channel support
Add tie channel support (P5) to the bottom of the frame.
Rotate into place BEFORE dropping in slot.
5.
Assemble 2nd shelf
Recommend adding next section at notch 8 from the bottom
of the post. Add the horizontal and side support beams. Add
tie channel support and shelf.
P3
2.
Assemble bottom
Repeat Step 1 to assemble the other 3 corners, completing
the bottom shelf.
4.
Add 1st shelf
Add laminate shelf to the bottom of the frame. Gently place
laminate shelf on beams and tie channel support.
6.
Assemble 3rd shelf
Recommend adding next section at notch 14 from the
bottom. Add the horizontal and side support beams. Add
tie channel support and shelf.
NOTE: Recommend adding 3 shelves to the bottom half
of the shelving rack for better support. Make sure to install
shelves before doing next step.
5