Bestway Steel Pro Mode D'emploi page 6

1
A
A
A
A
A
A
A
A
2
A
A
C
3
D
F
4
5
A
A
A
A
A
A
A
A
A
C C
C
C
C
C
C
C
C
C
C
B
E
1in. - 2in.
2-5 cm
Connection Valve Assembly
For pool with connection valve
NOTE: If you want to connect other pool cleaning kits to the pool through the connection valve, use
a Phillips screwdriver to disassemble the Debris Screen from the Connector.
C
Filling Pool with Water
ATTENTION: Do not leave pool unattended while filling with water.
1. Fill pool until water capacity is 90%, DO NOT OVERFILL as this could cause the pool to collapse.
In times of heavy rainfall you may need to empty some of the water to ensure the level is correct.
2. When filling the pool is completed, check that the water is not collecting on any side to ensure the
pool is level.
IMPORTANT: If pool is not level, drain water and re-level ground by digging out. Never attempt to
move the pool with water in it, serious personal injury or damage to the pool may result.
WARNING: Your pool may contain a great deal of pressure. If your
pool has any bulge or uneven side then the pool is not level, the
sides may burst and the water may discharge suddenly causing
serious personal injury and/or damage to property.
3. Check pool for any leaks at valves or seams, check ground cloth for
any evident water loss. Do not add chemicals until this has been
done.
NOTE: In the event of a leak, patch your pool using the underwater
adhesive repair patch provided. Refer to the FAQ's for further
information.
Proper Water Level
NOTE: Drawings for illustration purpose only. May not reflect actual product. Not to scale.
POOL MAINTENANCE
Warning: If you do not adhere to the maintenance guidelines covered herein, your health might be
at risk, especially that of children. Pool water treatment is essential for the safety of the users. Using
chemicals inappropriately will cause property damage and personal injury.
NOTE: The pump is used to circulate the water and to filter small particles. In order to keep your
pool water clean and hygienic, you must also add chemicals.
1. It is recommended not to fill the pool with catchment water, drilling water, or drainage well water:
these waters generally contain polluted organic substances including nitrates and phosphates.
Filling pools with water from the public network is advised.
2. Always keep your pool clean and apply the correct pool chemicals. Unsanitary water is a serious
health hazard. It is recommended to use disinfectant, flocculant, acid or alkali chemicals to treat
your pool.
3. Clean the PVC liner regularly with non-abrasive brushes or a pool vacuum cleaner.
4. Throughout the season, the water filtration system must run long enough each day to clean the
entire volume of water in the pool.
5. Check the filter cartridge (or sand in a sand filter) regularly and replace dirty cartridges (or sand).
6. Regularly check the screws, bolts and all the metal parts for rust. Replace if necessary.
7. If it rains, check that the water level is not higher than the specified level. If water exceeds the
specified levels, drain the pool to the specified level.
8. Do not use the pump when the pool is in use.
9. Cover the pool when not in use.
10. For pool water treatment, the pH value is very important.
ATTENTION: Do not leave the drained pool outside.
The following parameters ensure good quality water.
6
A
0°
B
S-S-005662