Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INTERIOR-MOUNTED VENT MOTOR
Determine which venting method is best for your application.
Vent system can terminate either through the wall or floor.
Island location
Front (standard) mounted
blower motor
A. Down vent
NOTE: For island locations, the blower motor can be mounted for
right, left, or rear venting if needed for your application. Most
island applications would still require the venting to be directed
down through the floor.
Built-in cabinet locations
A
C
A. Down vent
B. Rear vent
C. Left vent
D. Right vent
8
INSTALLATION INSTRUCTIONS
Venting Methods
Rear mounted blower motor
A
B
Island Location
Vent system installed under a concrete slab using PVC
sewer pipe.
Front (Standard) Mounted Blower Motor
A
M
A
L
Rear Mounted Blower Motor
A
M
L
A. Wall cap
B. 6" (15.2 cm) round metal vent
C. 16" (40.6 cm) maximum
D. 6" (15.2 cm) round PVC sewer pipe
E. 6" (15.2 cm) round metal vent
F. 6" (15.2 cm) round PVC coupling
G. Concrete slab
H. 6" (15.2 cm) round PVC sewer pipe
I. 6" (15.2 cm) round 90° PVC sewer pipe elbow
J. Tightly pack gravel or sand completely around pipe.
K. 6" (15.2 cm) round 90° PVC sewer pipe elbow
L. 6" (15.2 cm) round PVC coupling
M. 12" (30.5 cm) minimum
D
Calculating Vent System Length
It is recommended that you use round vent instead of rectangular
vent, especially if elbows are required. If rectangular vent is
required, it should be transitioned to 6" (25.4 cm) round vent as
soon as possible.
B
D
C
K
J
B
D
C
K
J
E
F
G
H
I
E
F
G
H
I
Publicité
Table des Matières
