KitchenAid KIRD861VSS Guide D'utilisation Et D'installation page 12

7. Plug in the wire connector to the blower motor.
A
B
A. Blower motor
B. Wire connector
8. Place the vent extension for the 6" (15.2 cm) diameter venting
over the vent exhaust and screw into place using the 4
screws.
A
A
A. Vent extension screws (4)
9. Replace the vent box over the blower motor.
A. Blower motor
B. Vent box
12
B
A
10. Place the bottom tab of the blower box into the bottom
mounting channel.
A. Blower box
B. Bottom mounting channel
11. Tilt blower box top tab so it is flush with the vent box panel
and position it under the top mounting bracket.
12. Slide bracket into the "Z" slots.
13. Tighten the 2 hex/slotted head screws to secure.
14. Place the small vent cover over the hole in the vent box and
secure in place with the 4 screws.
15. See "Complete Installation - Interior Mounted Motor" section.
B
A