Husqvarna S 138i Manuel D'utilisation page 18

4. To remove the battery, press the 2 release buttons
at the same time and pull out the battery.
5. Charge the battery if it is weak. For more
To charge the battery on page 16 .
information, see
To operate S 138C
To start the product
1. Connect a power cord to the socket below the
handle.
2. Put the power cord in the power cord holder. Refer
To use the power cord holder (model S 138C) on
to
page 10 .
3. Stay behind the product.
18
4. Loosen the start inhibitor.
5. Push the motor brake handle in the direction of the
handlebar.
To stop the product
1. Release the motor brake handle to stop the motor.
2. Disconnect the power cord from the mains and then
from the product.
937 - 005 -