DURAVIT SensoWash 254459 Série Notice De Montage page 6

Important information
About the mounting instructions
These mounting instructions come as part of
the Duravit Shower WC and should be read
carefully prior to installation.
Explanation of the key words and symbols
DANGER! At high risk of fatal hazards or
serious injuries
NOTE! To avoid property damage
Link to the Electrical Installation section
Link to the installation information in
this section
Link to the Water Installation section
Inspection (e.g. for scratches)
Do not kink hose
Check for leaks
Flush
Target readership and qualifications
The Shower WC and associated water connec-
tion may only be installed by qualified plumb-
ers. The electrical installation may only be
carried out by qualified electricians.
NOTE!
Local installation regulations, country-specific
standards and the low voltage directives must
be observed at all times.
NOTE!
Do NOT install the Shower WC in rooms where
there is a danger of frost. The room tempera-
ture must not be less than 4 °C (39°F).
Safety instructions
DANGER!
Risk of fatal electric shock.
> Do NOT remove individual Shower WC
components.
6
Installation instructions
These instructions describe the installation of
the SensoWash wall-mounted toilet with an
installation kit for front-wall elements with
ductwork. The instructions enclosed with the
wall-mounted toilet are only valid for the wall-
mounted toilet without an installation kit and
should therefore be disposed of.
The Shower WC unit installation is described in
separate instructions.
Checking the pre-installation
4
(Diagram 4)
> Check whether the push plate of the
front-wall element and wall-mounted
toilet are disassembled. Disassemble
other elements if necessary.
> Check whether the electrical installation
has already been carried out.
Drilling a hole to the ductwork in the
5
front-wall element (Diagram 5)
> Take clearances x and y to the front-wall
element from the documentation.
> Mark the drill holes.
> Drill a hole to the ductwork.
16
Measuring clearance y (Diagram 16)
Installing sound insulation set
19
(Diagram 19)
> if the sound insulation set is included
with the delivery, take z into account in
the clearance between the wall and bolt:
Clearance = z+y+22mm (55/64") .
> Screw the bolt onto the hanger bolt until
you achieve the calculated clearance to
the wall.
> Install the sound insulation set.
Attaching the ceramics to the wall
27
(Diagram 27)
> Position the ceramics on the wall.
Ensure that the hose is not kinked or
trapped.
SensoWash_MAL_WWC+Montageset#100691_56918/16.12.3