In The Event Of A Problem - CALOR 6346 Mode D'emploi

M o re thorough cleaning can only be carried out by an approved service agent
This operation is not covered by the guarantee.
Changing the power lead.
If the power lead is damaged, it must be replaced by an approved service centre, as special tools
a re needed to disassemble this appliance.

11. IN THE EVENT OF A PROBLEM

P ro b l e m
Your appliance
does not heat.
For any other problems, please contact an approved service centre (see enclosed list).
I m p o rtant : special tools are needed to repair this appliance.
C a u s e s
It is not plugged in.
The On/Off dial is on 0.
The thermostat position is set
too low compared with the
t e m p e r a t u re in the ro o m .
In the event of abnorm a l
heating, a safety limiter
automatically cuts out the
a p p l i a n c e .
E.g.: Excessive dust on air
vent (G).
S o l u t i o n s
Plug it in.
Tu rn it to position .
Set the thermostat to a higher
s e t t i n g .
Tu rn the dial to position 0 and
eliminate the cause of overh e a t i n g .
When the temperature of the appliance
re t u rns to normal, turn the appliance back
on, by turning the dial to position .