Electrical Connection; Appliance Description; Switching The Appliance On/Off - Beem Stand- & Tischgrill BBQ Mode D'emploi

EN

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions on
the electrical connection must be be ob-
served:
■ Before connecting the appliance,
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. The
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
■ The mains socket must be protected
by at least a 10 A automatic circuit
breaker.
■ Ensure that the mains cable is undam-
aged and is not laid over sharp edges.
■ The mains cable must not be pulled
tightly, bent or come into contact with
hot surfaces.
■ Route the mains cable to prevent risk
of tripping.
■ If the appliance is connected via an ex-
tension cable, the cable cross-section
must be at least 1.5 mm² and be ap-
proved for outside use.
■ The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.
BEEM - Elements of Lifestyle
BBQ standalone & tabletop grill

Appliance description

(see illustration on the left fold-out)
1 Grill grate
2 Cover
3 Grill plate
4 Thermostat
5 Indicator light
6 Pedestal
7 Drip tray
8 Plastic housing
9 Heating element
10 Clip for hooking on the cover
11 User manual (not illustrated)

Switching the appliance ON/Off

To switch on the appliance, proceed as
follows:
Insert the plug into the mains socket.
‹
Turn the thermostat (4) clockwise
‹
from level 1 to level 5 to increase the
temperature and anticlockwise to de-
crease the temperature.
To switch off the appliance, proceed as
follows:
Turn the thermostat (4) anticlockwise
‹
until it stops.
Pull the plug out of the mains socket.
‹
NOTE
► The temperature remains high for a
while after switching off the appli-
ance.
► Allow the appliance to cool down
completely.
17