exonda S32 Mode D'emploi page 33

Safety information
DANGER! Fire hazard
Never leave the device unattended while it is plugged in.
Risk of ignition – Flammable mousses, sprays, gases or highly flammable ma-
terials – e.g. synthetic tulle – must not come into contact with the heating
heaters or be used near the appliance.
Observe the product information supplied by the manufacturer.
Do not use benzene, paint thinners or other highly flammable substances for
cleaning.
The appliance must not be covered by towels or similar items.
Under no circumstances should the ventilation screens of the appliance be
covered or the appliance put down on a soft surface such as a bed or sofa, as
this may block off the ventilation openings. Make sure that the ventilation
openings are not blocked by foreign bodies such as hair, etc.
Do not use the appliance outdoors or in places where aerosols (sprays) are
used.
DANGER! Risk of injury through burning
The heating heaters become hot during treatment.
Do not knock the appliance during treatment.
Do not touch the hot surfaces of the device.
Allow the device to cool down completely before you clean it or put it away.
WARNING! Risk of injury
Only accessories approved by the manufacturer should be used.
Sudden release of spring arm (only wall-mounted version):
The spring arm of the wall-mounted version contains a powerful spring.
When the appliance is dismantled, the spring arm is suddenly released up-
wards and may cause serious injury.
The appliance may only be mounted / dismantled by a specialist (electrician,
technical expert) or staff with a comparable qualification according to the
valid instructions.
Sudden drop of wall arm (only wall-mounted version):
Do not place any additional loads on the wall arm.
CAUTION – Damage to property
Wall-mounted version: Prevent the appliance from colliding with walls or
nearby objects. An optional wall arm stop can be mounted on the wall brack-
et by the Technical Customer Service Centre.
The protective filter film and the temperature sensor are sensitive to touch
and easily scratched. Do not touch or clean the protective filter film and tem-
perature sensor.
Make sure that the lower heating heater is positioned above the back of the
chair.
Do not use benzene, paint thinners, heavy-duty or abrasive cleaning agents.
An ambient temperature of 15 °C to 35 °C in the salon should be maintained.
A relative humidity of 95 % must not be exceeded.
Do not set up the appliance in direct sunlight, near high temperatures, heat-
ers or in damp rooms.
GB
31