Resetting The Adjustments (Reset); Additional Settings (Option) - Sony SDM-N50PS Mode D'emploi

Resetting the adjustments (RESET)

You can reset the adjustments.
1
Press the MENU button.
The main menu appears on the screen.
Press the M(+)/m(–) buttons to select 0 (RESET)
2
and press the OK button.
The RESET menu appears on the screen.
You can reset the adjustment data in either of the following
two ways:
Resetting the adjustment data most appropriately
for the current input signal
Press the M(+)/m(–) buttons to select SCREEN RESET
and press the OK button.
The automatic picture quality adjustment function of this monitor
automatically adjusts the phase, pitch, and picture position, to the
most appropriate value. If this function is activated, the phase is
automatically adjusted whenever the monitor receives the same
input signal.
The RESET menu is automatically returned to the main menu
after the adjustment data is reset.
Resetting all of the adjustment data for all input
signals
Press the M(+)/m(–) buttons to select ALL RESET and
press the OK button.
The RESET menu is automatically returned to the main menu
after the adjustment data is reset.
To cancel resetting
Press the M(+)/m(–) buttons to select
OK button.
The RESET menu returns to the main menu without resetting the
adjustment data.
16

Additional settings (Option)

You can adjust the following options:
• BASS BOOST
• BACKLIGHT
• POWER SAVE
• LANGUAGE
• MENU LOCK
1
Press the MENU button.
The main menu appears on the screen.
Press the M(+)/m(–) buttons to select m.
2
The option menu appears on the screen.
Press the M(+)/m(–) buttons to select the desired
3
option item and press the OK button.
Adjust the selected option item according to the following
instructions.
Boosting the bass (bass boost function)
This option increases the bass output.
First press the M(+)/m(–) buttons to select
BOOST) and press the OK button. Then press the
M(+)/m(–) buttons to select either ON or OFF.
Adjusting the backlight
If the screen is too bright, adjust the backlight.
First press the M(+)/m(–) buttons to select
(BACKLIGHT) and press the OK button. Then press
the M(+)/m(–) buttons to adjust the desired light level.
Setting up the power saving mode
This monitor has a function which enables it to enter the power
and press the
save mode automatically according to the power saving settings
of the computer. You can prevent the monitor from entering the
power saving mode by setting the following option to OFF.
First press the M(+)/m(–) buttons to select
SAVE) and press the OK button. Then press the
M(+)/m(–) buttons to select either ON or OFF.
Selecting the on-screen menu language
See "Selecting the on-screen menu language (LANGUAGE)" on
page 11.
Locking the menus and controls (the menu lock
function)
You can protect adjustment data by locking the menus and
controls.
First press the M(+)/m(–) buttons to select
LOCK) and press the OK button. Then press the
M(+)/m(–) buttons and select ON.
Only the power switch, and
menu will operate. If any other items are selected, the
appears on the screen.
To cancel the menu lock function
Repeat the procedure above and set and
(BASS
(POWER
ZZ...
(MENU
(MENU LOCK) of the option
mark
(MENU LOCK) to OFF.