Alarm Clock - Hama Black Line Mode D'emploi

5.2. Alarm clock

Setting the alarm times
This alarm clock allows you to set two different alarm times with a progressively louder
alarm signal.
• Press and hold the ALARM button (H) for approximately 3 seconds to set the time of
the alarm displayed. The hours display begins to ash.
• Press the + button (F) or the - button (G) to select the hour for the alarm time,
and con rm your selection by pressing the ALARM button (H). The minutes display
begins to ash.
• Repeat the process to set the minutes for the alarm time.
• Repeat the process to set the second alarm time.
• If you do not make an entry for 20 seconds, you automatically exit Settings mode.
• Activate the alarm by pressing the corresponding slide switch
outside of the alarm clock. If the alarm is activated, the red indicator light (C + D) is
visible, and the alarm symbol
Alarm mode exit/snooze function
• If the alarm is triggered, the alarm symbol
will sound.
• Press any button (except the SNOOZE/LIGHT button M)) to stop the alarm.
• Otherwise, it will stop automatically after 2 minutes.
Note – Snooze function
While the alarm signal is sounding, press the SNOOZE/LIGHT button (7) to activate
the snooze function. The alarm symbol
alarm signal will be stopped for 5 minutes, after which it will sound again.
5.3. Temperature
• Press the - button (G) to switch the temperature display (8) between °C and °F.
• Press the + button (F) to display the minimum/maximum temperature and humidity.
5.5. Backlight
• If you press the LIGHT/SNOOZE button (M), the display lights up for approximately
10 seconds.
2
and/or will appear in the display.
1
/
/ and
or
1
will begin to ash and an alarm
will begin to ash. The
2
on the
7