Machine Assembly - GGP ITALY B 28 Manuel D'utilisation

6
EN
4. MACHINE ASSEMBLY
IMPORTANT
some of the components disassembled and the
fuel tank empty.
WARNING!
gloves to handle the cutting devices. Mount
the components very carefully so as not to
impair the safety and efficiency of the ma­
chine. If in doubt, contact your dealer.
1. COMPLETING THE MACHINE
1a. "MONO" models (Fig. 1)
– P osition the upper part (2) with the front grip's
guard on the drive tube (1).
– F asten the lower cap (4) inserting the pin (4a) in
one of the three holes on the drive tube.
– Fully tighten the screws (4).
1b. "DUPLEX" models (Fig. 2)
– L oosen the screws (5) and remove the cap (4)
from the support (2).
– P ut the handlebar (1) into the seating in the sup-
port (2), located on the drive tube (3), making
sure that the controls are on the right.
– F it the cap (4), fully tightening the screws (5).
– F asten the casing (6) of the controls to its cable
fastener (7).
2. M OUNTING THE ROD
(Models with separate rod – Fig. 3)
– P ull out the stop pin (5) and push the lower part
of the rod (4) right down until the stop pin (5)
slots into the hole (6) in the rod. This is easier to
do if you rotate the bottom of the rod (4) slightly
in both directions. The pin (5) is in place when it
is completely lodged in the hole.
– Lastly, tighten the knob (7) securely.
3. FITTING THE GUARDS
WARNING!
vided with a specific guard. Never use guards
other than those indicated for each cutting
device.
The machine is supplied with
Always wear strong work
Each cutting device is pro­
• 3 or 4 point blade (Fig. 4)
WARNING!
and fit the blade guard.
– R emove the blade (if fitted) as described in
paragraph 4.
– T he guard (1) is fixed to the angle transmission
(2) by four screws (3).
• Cutting line head (Fig. 5)
WARNING!
line head the additional guard, with line cut­
ting knife, must always be fitted.
– R emove the blade (if fitted) as described in
paragraph 4.
– T he guard (1) is fixed to the angle transmission
(2) by four screws (3).
– A ssemble the additional guard (4) fastening it
into place on the guard (1).
4. R EMOVING AND REFITTING
THE CUTTING DEVICES
WARNING!
devices or ones homologated by the Ma nu­
facturer.
• 3 or 4 point blade (Fig. 6)
WARNING!
and fit the blade guard.
NOTE
left­hand thread and so must be unscrewed in a
clockwise direction and screwed up anticlockwise.
– I nsert the wrench supplied (2) into the specific
hole in the angle transmission (3) and rotate the
blade (1) by hand until the wrench enters the
inner hole, blocking rotation.
– R emove the split pin (4) and unscrew the nut (5)
in a clockwise direction.
– P ull out the washer (6) and the outer ring-nut (7)
and remove the blade (1).
MACHINE ASSEMBLY
Wear protective gloves
When using the cutting
Use only original cutting
Wear protective gloves
The fastening nut (5) has a