Section 3 - Troubleshooting - Keurig MINI B30 Brewer Manuel D'utilisation

SECTION 2 De-Scaling Your Brewer (continued)
Fill the Hot Water Tank with  ounces of bottled water, close the water
Step 6:
fill lid, place a cup on the Drip Tray Plate and perform a brew.
Repeat Step  three times using bottled water (with no K-Cup in place)
Step 7:
to cleanse the Brewer plumbing and get rid of any residual taste from
the vinegar. The Brewer is now ready for normal use again.
Service
Beyond these recommended cleaning and maintenance procedures this
Brewer is not user serviceable, for service please refer to the Warranty
section in this guide.
SECTION 3
Situation
Brewer does not have power
• Make sure the Power Button is pressed and is illuminated
• Plug Brewer into an independent outlet.
• Check to be sure that it is plugged in securely.
• Plug into a different outlet.
• Reset your home's circuit breaker if necessary.
Brewer will not brew when used for the first time
• If Brewer is cold/frozen, wait for at least two hours for it to reach room
temperature before powering on.
Brewer will not brew
• Check to make sure there is water in the Hot Water Tank.
• Place a cup on the Drip Tray Plate.
• Check to be sure you are not using a clear, glass mug. Cup sensor will not
"read" the glass mug and the "Place Mug" light will flash.
Brewing a partial cup
• The Exit Needle may be clogged. (refer to page ).
• Clean K-Cup Holder if necessary and rinse under faucet. (refer to page ).
• De-scale the Brewer (refer to page ).
• If you have repeated the de-scale procedure on your Brewer two times and the
Brewer is still not brewing, contact Customer Service at 1..01.BREW
(23).
My Brewer shuts off automatically
• Check to make sure that there is a cup on the Drip Tray Plate.
10
Toubleshooting