Application And Operation - ceramill argotherm 2 Mode D'emploi

A P P L I C A T I O N A N D O P E R A T I O N
WARNING:
E N
The mains cable may not be damaged!
▷ Do not place objects on the mains cable.
▷ Lay the mains cable in such a manner that
nobody can step on or trip over it.
NOTE:
Do not insert the mains plug before the heating
elements have been inserted.
▷ Set the mains switch to the 0 position.
▷ Connect the enclosed mains cable to the socket
intended for this purpose on the rear of the fur-
nace.
Fig. 8
▷ Connect the other end of the cable to the socket
outlet with earthing contact.
The mains cable may only be exchanged by an
approved identical one.
30
6

Application and Operation

Before starting-up the furnace, it should
acclimate at the set-up location for 24
hours. Swift heating up in cold condition
can cause damage to the heating rods (for
example, burning-through).
During the first heating up, there may be
odour nuisance due to binding agent
fumes escaping from the insulation mate-
rial.
▷ Provide for thorough ventilation of the
furnace set-up location when heating up
for the first time.
DANGER:
Hot air at the outlet opening!
▷ Do not reach with your hand at or above the
outlet opening.
▷ Do not place objects on the furnace!
WARNING:
Danger of fire and explosion!
The furnace surfaces become very warm.
▷ Do not place objects on the furnace!
NOTE:
Insufficient sintering results due to faulty tem-
perature control!
▷ Prior to every process, check the thermoele-
ment for damage.