Time Measuring With The Dgt960; Temporarily Pause The Clock; Starting A New Game; Sound Signal - DGT 960 Manuel D'utilisation

3. Time measuring with the
DGT960
On first use the DGT960 is set to the time measuring
method "Game Timer" with 5 minutes thinking time for
both players (see 7 and 8). The sound is on (see 6). The
triangular signs blink to indicate that the clock is in the
setup mode.
To start playing, you should briefly push the central
start/stop button
blinking to indicate that the timer of one of the players
should be started. When you push one of the red player
buttons, the opponent's timer will start the count down.
After finishing his move, the player will push his red
player button and the countdown of the other player will
start or continue.
4.

Temporarily pause the clock

Count down of the clock can be temporarily be
interrupted by pressing the central Start/Stop button
Press this button once more to restart the clock. During
the pause the way the clock was set can be adapted (see
9).
5.

Starting a new game

Press half a second on the On/Off button
DGT960 is ready for a new game. The settings of the
clock will be identical to the previous game.
6.

Sound signal

You may switch the sound signal on or off at any time
during the game by pressing the sound button
sound is switched on, you will hear warning beep signals
during the last five seconds prior to falling of your flag.
7. Setting of the time measuring
modes and time-controls
After the DGT960 has been activated, you will notice the
time-control and settings used during the last game. The
time available to both players are surrounded by two
blinking triangles. By pressing on the Start/Stop button
, you could start the game, but you may also change
the settings first.
4
. The triangular markings will stop
.
and the
. When