Blaupunkt TSA 280 Guide De Montage page 10

TSA 280 / TSA 2120
Channels
Max. power
4 ohms
Max. Power
2 ohms
RMS power
4 ohms
RMS power
2 ohms
Frequency
response
Signal-to-noise
ratio
Input sensitivity
Stability
Low pass filter
(Low Pass)
High pass filter
(High Pass)
Subsonic filter
Remote control
for bass level
Dimensions
WxHxD (mm)
Inner housing
Outer housing
Positive/negative connection
The cross section of the positive and
negative cables must be at least 6 mm
Use cable grommets to protect cables
against sharp-edged holes. Securely
screw a standard 6 mm
to an interference-free earth connection
point (bolt connected to the car body, car
body sheet metal) – though do not con-
nect it to the negative terminal of the bat-
tery. Scratch the surface down to the bare
metal at the point at which the earth con-
tact is made and apply graphite grease.
10
TSA 2120
2/1
2 x 240 watts /
1 x 600 watts
2 x 360 watts
2 x 120 watts /
1 x 320 watts
2 x 180 watts
20 - 20000 Hz
> 95 dB/A
0.3 - 8 V
2 ohms
50 - 250 Hz
50 - 250 Hz
20 Hz, switchable
Yes
205 x 45 x 177
253 x 67.5 x 210
2
negative cable
Connection examples
Before you can connect the cables to the
amplifier, you must first detach the top half
Fig. 7,
8, 9 of the housing shell (see "Removing the out-
er housing").
Fig. 7,
9
Connecting the voltage supply ......... Fig. 4
Fig. 7,
Connection to car radios with
8, 9
RCA output ...................................... Fig. 5
Fig. 7,
Connection to car radios with
9
loudspeaker output .......................... Fig. 6
Loudspeaker connections ........ Fig. 7, 8, 9
Connecting the wire remote
control (REMOTE BASS) ............... Fig. 10
+12V
The switching line must be connected when
connection is carried out using the RCA jacks
or the loudspeaker jacks of the car radio.
GAIN control
You can use the GAIN control to adjust the
input sensitivity of the Blaupunkt power am-
plifier to the output voltage of your car ra-
dio's preamp output.
The setting can be adjusted between 0.3 V
and 8 V.
When connecting a car radio produced by
another manufacturer, you must adjust the
2
.
input sensitivity in accordance with the in-
formation provided by the manufacturer.
Please note that the GAIN control is not a
control for adjusting the volume!