emerio SG-123562.1 Mode D'emploi page 6

SG-123562.1
PARTS IDENTIFICATION
1. Temperature regulator
2. Temperature indicate line
3. Indicator light
4. Iron handle
5. Steam button & steam button lock
6. Soleplate
7. Water inlet cover
8. Water tank
9. Water tank handle
10. Thermal insulation stand
11. Unit base
12. Cord winding groove
13. Steam supply hose
BEFORE INITIAL USAGE
Remove all packaging material. Make sure the appliance is unplugged and the temperature regulator is set at
position "OFF".
Fill water into the water tank up to the max level marked on the water tank. The appliance must use pure water
or steam water, not tap water or other liquids.
How to fill water:
Grasp the water tank handle and press the separation button to pull out the water tank from unit base. Then
open the water inlet cover to fill in the proper water.
Insert the power plug in to a designated outlet and set the temperature regulator on the highest temperature
setting. After the indicator light goes off, press and hold the steam button for steam ironing and iron on an old
piece of cloth to remove possible residue. (Refer to "steam ironing")
Note:
1) With first use, these can be slight odour or smoke. But this is harmless and only of short duration. Make sure
there is adequate ventilation.
2) When you activate the steam function, the appliance may produce a pumping sound. This is normal; the
sound tells you that water is pumped into the appliance.
OPERATION
Before selecting the temperature, read the instruction manual for the iron or the care advice on the tag of
the clothing.
Note: If there is no care advice on the piece of clothing, then you should begin ironing with the lowest
temperature.
- 5 -
EN