Warm Tech CG3001 Traduction Des Instructions D'origine page 18

You can solve many common problems easily, saving you the cost of a possible service call. Try the
suggestions below to see if you can solve the problem before calling the service centre.
Problem
The heater does not
operate,even when it is plugged
in and the switch, thermostat are
switched on .
The heating element glowing
The appliance didn't heat up,
only ventilator worked
Abnormal noise
8. TROUBLE SHOOTING
Possible cause
The plug is loose, bad
connection
No power in socket outlet
The input voltage is too high or
too low
The air inlet grill is blocked
The switch was not put at
heating setting
The thermostat operated
The Non-self resetting cut-out
operated (only for the device
with this function)
The appliance is not stands
upright
Treatment
Pull out the plug, check the
connection of the plug and
socket. Then connect again.
Insert the plug in a proper
socket
Use power supply according to
the rating on the label
Keep the heater far way from
articles like curtain, plastic bag,
paper and other things which
can cover the inlet or can be
easily cover on the air inlet
Turn the switch to heat setting
Turn the thermostat and listen if
there is open/close voice. If
there is no click and the
thermostat is not damaged, the
heater will automatic switch on
when the appliance cooled
down
Disconnect the power , held the
stick and insert it in the reset
hole on the control panel ,press
down the reset button and
connect the circuit
Put the heater on a level
surface