ECOVACS ROBOTICS DEEBOT 4 Mode D'emploi page 19

No. Malfunction
Remote Control
failure (effective
5 control range of
Remote Control is
5m (16')).
Possible Causes
The batteries in the
Remote Control need to be
replaced.
DEEBOT 4 is powered
OFF or DEEBOT 4's
battery is low.
The infrared signal cannot
be transmitted because the
Infrared Emitter on Remote
Control or the Infrared
Receiver on DEEBOT 4 is
dirty.
There is other equipment
interfering with the infrared
signal to DEEBOT 4.
5. Troubleshooting
Solutions
Replace with new batteries making
sure they are installed correctly.
Make sure DEEBOT 4 is powered
ON and fully charged.
Use dry cotton cloth to wipe the
Infrared Emitter on Remote Control
and the Infrared Receiver on
DEEBOT 4.
Avoid using the Remote Control
near other equipment using infrared
signals.
17
EN