Miele STB 101 Turbo Mini Mode D'emploi page 10

en
Illustrations
The illustrations referred to in the text
are shown on the fold-out pages at
the end of these operating instruc‐
tions.
Turbobrush features
The Turbobrush is operated by the suc‐
tion power of the vacuum cleaner. It
has a rotating roller brush which is very
effective at vacuuming up thread, hair
and fluff.
Recommended use (dia. 01)
When using the Turbobrush please
also observe the warning and safety
instructions in your vacuum cleaner
instruction manual.
This Turbobrush is particularly suitable
for vacuuming upholstery, mattresses,
car seats and carpeted stairs.
It is also important to observe the
flooring manufacturer's cleaning and
care instructions.
Fitting the Turbobrush
 Connect the Turbobrush to the han‐
dle or suction tube on your vacuum
cleaner depending on how you wish
to use it.
Using the Turbobrush
 To achieve the best effect, pass the
Turbobrush slowly backwards and
forwards over the surface being va‐
cuumed.
10
Maintenance

Always disconnect the vacuum
cleaner from the electrical supply for
cleaning and maintenance work on
the Turbobrush. Switch off at the
wall socket and unplug it.
Removing threads and hairs
(dia. 02 - 04)
 Cut any threads or hairs that have
become entangled on the roller brush
with a pair of scissors (dia. 02).
Then run the vacuum cleaner to vac‐
uum up the bits.
For more obstinate tangles or block‐
ages inside the Turbobrush, the cover
can be opened. Any large particles can
then be easily removed (dia. 03).
 Twist the connector until the release
button is located in the centre of the
slot .
 Then press release button  and pull
the connector away from the Turbo‐
brush .
 Open up the brush compartment as
far as you can and then remove any
stubborn soiling from the compart‐
ment interior and from the roller
brush (dia. 04).
 Finally close the cover to the brush
compartment and push the connec‐
tor back into position over the release
button.