How To Connect Speaker Cables To The Input And Output Terminals Of The Speakers; Before Connecting - Yamaha NS-P230 Mode D'emploi

How to connect speaker cables to the input and output terminals
of the speakers
For connections, keep the speaker cables as short as possible. Do not bundle or roll up the excess part of the cables. If the
connections are faulty, no sound will be heard from the speakers.
Main/center/rear speakers
Rear center speaker (for NS-P236)
One side of the provided speaker cable has a white broken
line and the other side has no line.
Connect the (+) terminals on both the speaker and the
amplifier using the side with a white broken line. Connect
the (–) terminals on both components using the side with no
line.
Red: positive (+)
Black: negative (–)
Subwoofer (INPUT1/OUTPUT terminals)
Connect the (+) terminals on both the subwoofer and the
amplifier using one side of the cable. Connect the (–)
terminals on both components using the other side of the
cable.
Red: positive (+)
Black: negative (–)

Before connecting

Remove the insulation coating at the extremity of each
speaker cable by twisting the coating off.
How to Connect:
1
White broken line
2
3
4
Note
Do not let the bare speaker wires touch each other as
this could damage the speaker or the amplifier, or both
of them.
Press and hold the terminal's tab, as shown in the
figure.
Insert the bare wire.
Release your finger from the tab to allow it to lock
securely on the cable's wire end.
Test the firmness of the connection by pulling lightly on
the cable at the terminal.
9
E-