Agu SN10 Mode D'emploi page 72

6 Attach the medication chamber to the main unit and close the lid of the main unit. Keep
all parts in a clean place.
7 Disinfection.
WARNING
• In case of infectious diseases, the device shall be disinfected after each use and all parts shall
be sterilized. Alcohol-containing disinfectants can be used. Make sure that no disinfectant
residue is left on the parts to ensure safe inhalation during subsequent use.
• Disinfect the mouthpiece by boiling at 100˚C for 1 minute.
• Please be careful not to boil the medication chamber and the mask as they may be damaged.
• Dry the parts thoroughly.
HOW TO REPLACE MEDICATION CHAMBER
Under normal conditions, the medication chamber service life is 12 months (when spraying physiologi-
cal solution 3 times a day for 10 minutes at room temperature (23°C) with a total duration of no more
than 30 minutes). However, spraying efficiency may reduce in less than 12 months depending on how
you use the medication chamber or when using certain types of medications. If the nebulizer does not
work properly or the spray rate is significantly reduced after cleaning, replace the medication chamber
with a new one. If you want to buy the medication chamber, please contact the retailer from whom you
purchased the product or your nearest distributor.
ATTENTION
• To avoid breakage, make sure that you press the «Push» button to remove medication cham-
ber from the main unit.
• Do not touch the membrane with your fingers or other objects to avoid tearing it.
1 Take decorative panel away.
2 Press the «Push» button to remove medication chamber from the main unit.
72
100°С ~3 min