EINHELL OPAL Instructions De Montage page 10

later on to attach it to the steel base (optional
accessory). If you are not using a steel base then
you do not need to fit these bolts.
12/d: Slide one bolt into each pre-assembled floor
profile guide rail (bolt should be approx. 10 cm from
the edge – see assembly preview).
Page 51
13
Pre-assembly of the rain guttering
Important note for 3-panel greenhouses:If you
have purchased a 3-panel greenhouse, skip step
13 and continue with assembly step 15.No pre-
assembly of the rain guttering is required on 3-panel
greenhouses.
Bottom illustration: Assembly preview of a
greenhouse with 4 panels
Page 52
Top illustration: Assembly preview of a greenhouse
with 5 panels
Middle illustration: Assembly preview of a
greenhouse with 6 panels
Bottom illustration: Assembly preview of a
greenhouse with 7 panels
Page 55
14
Pre-assembly of the ridge
Important note for 3-panel greenhouses:
If you have purchased a 3-panel greenhouse, skip
step 14 and continue with assembly step 15.
No pre-assembly of the ridge profile is required on
3-panel greenhouses.
Middle illustration: Assembly preview of a
greenhouse with 4 panels
Bottom illustration: Assembly preview of a
greenhouse with 5 panels
Page 56
Top illustration: Assembly preview of a greenhouse
with 6 panels
Middle illustration: Assembly preview of a
greenhouse with 7 panels
14/a: Slide the bolt with the fluted side first into the
designated opening of the ridge profile.
Page 58
15
Assembly of the floor profile on the front
and rear walls
15/a: Slide the floor profile which was already pre-
assembled in step 12 (side) into the corner cover on
the corner profile.
10
ABA_OSR_Teil1_Titel+GB.pmd 10
Important note: If you have purchased a 5-panel
house, the side profiles must be assembled in such
a way that the two shorter profiles (1414 mm) face
the front wall.
Page 59
16
Assembly of the rain guttering profile on
the front and rear walls
16/a: Slide the rain guttering profile as far as it will go
onto the front or rear wall. It may be necessary to
realign the corner and gable profiles to allow the rain
guttering to be inserted with a perfect fit. To do this
you will need to loosen the bolts on the assembly
panel.
Important note: If you have purchased a 5-panel
house, the rain guttering profiles must be assembled
in such a way that the two shorter profiles (1414 mm)
face the front wall.
Page 60
17
Assembly of the ridge profile on the front
and rear walls
17/a: Slide the ridge as far as it will go onto the front
or rear wall. It may be necessary to realign the gable
profiles to allow the rain guttering to be inserted with
a perfect fit. To do this you will need to loosen the
bolts on the assembly panel.
Important note: If you have purchased a 5-panel
house, the ridge profiles must be assembled in such
a way that the shorter profile (1414 mm) faces the
front wall.
Page 61
18
Assembly of the side struts
18/a: On the side struts, install one bolt approx. 5 cm
from both the top and bottom edge. Please check the
exact quantity required for your particular greenhouse
model.
18/b: On the remaining side struts, install one bolt
approx. 5 cm from the bottom edge. Two bolts are
installed at the top, one approx. 10 cm, the other
approx. 5 cm from the edge.
Page 62
18/c: Assemble the side struts with the four pre-
assembled bolts (see step 18/b) on the gusset plates
on the floor profile and the rain guttering.
Page 64
19
Assembly of the roof struts
Note: The side struts (roof) are inserted in the next
step. Please make sure that you refer to the relevant
04.04.2006, 15:08