Novy Cloud 230 Instructions D'installation page 12

2
• Take the mounting plate from the packaging and place it in the centre as seen from the cooking plate against the
ceiling. Make sure that the drawn centre line is aligned with the cut-aways in the mounting plate.
• First draw, drill and fasten the central screw at the indicated middle point.
• Do not fully tighten the screw yet.
Make sure that the electric connection falls within the left or right opening of the mounting plate.
3.
• Mark the 6 mounting points (in the 4 corners and 2 in the middle of the long sides).
• Carefully turn the mounting plate a quarter turn in order to be able to drill the 6 fastening holes. Turn back the moun-
ting plate and fasten the 6 screws.
• The mounting plate is attached to the ceiling with 7 screws.
4.
4 metal cables have been attached to the hood. - Place these 4 cables in the opening provided in the mounting plate.
5a.
The minimum distance between the left and/or right side of the Cloud up to a wall must be greater than 50 cm.
Only use the air conductor (990.271) in the following situation:
• The distance between the left and/or right side of the hood up to a wall must be between 50 cm and 100 cm. Other-
wise go on to step 6.
• When attaching the air conductor, the front where the air is blown must be at 100 cm from a wall.
• This conductor makes sure the air is not blown out vertically to the left or the right, but that it bends away to the front
side of the hood at an angle of 70°.
5b.
Fasten the conductor with 2 screws (906.151) in the hood.
6.
• The hood can be hoisted up using the metal cables. The adjuster can be found at the place where the cable enters
the hood.
• The cable can be extended by pressing this adjuster. The cable will be locked as soon as the adjuster is no longer
pressed. The cable can still be slid in at this moment. Make sure that the cables disappear in the hood.
• Stop about 10 cm below the mounting plate.
• The electric connection can now be made. Attention, do not carry out any mounting activities while the power supply
is switched on. Ensure the power supply has been switched off. And ensure the on/off switch is in the off position.
After having made the electric connection, hoist or press the hood fully into the mounting plate.
7.
Fasten the hood in the mounting plate by tightening the 5 screws (906.151) on the front and rear sides.
8a – 8b.
• Hook the lower plate in the hinges by keeping the lower plate in a position that is approximately 90° relative to the up-
per plate.
• Normally, when the lower plate of the hinge is gently released, the hinge will continue to hang at an angle of approxi-
mately 87°. However, in order to prevent it from falling, the lower plate must be held.
9.
• Make sure both elements are well hooked together.
10.
• Attach the damper by clicking it to the lower plate by holding the lower plate with one hand and operating the damper
with the other.
• Remove the plastic from the filters. Place the aluminium fat filters (230.020) and the monoblock filters (230.060).
EN 12